Specifications

13.0 ContinuedFrequently Asked Questions
Q: I can not get an image out of my Satellite receiver.
A: Some receivers output 1080i and 720p as RGBHV. The current version of TVP-1000 firmware only
supports video resolution on the YPbPr.
Q: Is there an easy way to do translucent PiP.
A: With single PiP selected use the up and down arrows on the remote to control how much the image is
blended.
Q: PiP on/off button on the remote does not work properly.
A: The PiP on/off is meant to turn on and off the last selected PiP mode. It remembers what the last mode was
and returns back to it. Until a mode is selected for the first time it will do nothing.
Q: I do not get an image from my PC.
A: Make certain it is set for a standard VESA resolution. Some computers use none standard frequencies even
though the resolution is the same. If you are using a laptop make certain the laptop is set to output a signal.
Some laptops have to be turned on while connected to a device and others have a function key selection to use
the VGA output connector.
Q: My laptop shuts down when it is connected to the 15pin HD.
A: Some laptops will not work if pin 9 of the VGA connector is present. A quick fix is to break off pin 9 of the
male 15 pin HD connector on the cable. It only needs to be done to one side.
-24-