Specifications

4.0 Installation
Before the TVP-1000 board is installed into the Pioneer plasma, the following must be setup:
1) With the Plasma power off (use main power switch on back of plasma), remove the card slot cover and insert the
TVP-1000 board. Secure the TVP-1000 using the screws from the cover.
2) If using RS-232 control connect the supplied black 6 pin - 6 pin Mini Din cable from the TVP-1000 control port to the
Pioneer’s Combo out port.
3.0 Unpacking
(1) - TVP-1000
(1) - Installation and Operations Manual
(1) - Control Cable [6 pin mini DIN Male - 6 pin mini DIN Male]
(1) - 47 Button Remote IRC-1a (Note: Units purchased without a remote can be upgraded. Contact your local dealer)
(1)-6PinMini DIN Male - Female 9 Pin (Firmware Upgrade / RS-232 Control Cable)
Note: Please examine the TVP-1000 for any signs of shipping damage.
2.0 : The TVP-1000 is an ELECTROSTATIC SENSITIVE unit.
Please observe precautions in handling.
2.1 : Static (Still) pictures will cause plasma “burn in”
and may damage the plasma display. Avoid prolonged usage
of the PiP and On Screen Display. When using static images,
reducing brightness and/or contrast can help reduce the risk of
damage to the plasma. Refer to the Pioneer owners and
technical manual about additional precautions and use with
expansion cards.
Warning
Caution
-2-