User manual

User Manual Page 28 of 74
(PVI-6000-OUTD-UK-W Rev.1.0)
Fig.12 - DC section cables
Power-One recommends using the Wind Interface box p/n PVI-7200-Wind-Interface-
US. Refer to the Aurora Wind Interface User Manual for more details.
3.7 Step 6/6 (optional): Connection of the frequency signal from the wind
turbine.
If the MPPT is set using the wind turbine frequency, the frequency signals available
from the rectifier (marked Wind Speed + , Wind Speed – on the AURORA Wind
Interface) shall be connected to the pins marked +WT and –WT on the terminal bock
of the AURORA inverter shown in Fig. 12.
3.8 How to access the internal terminal boards through the front panel
WARNING: Shock hazard! Before removing the front panel, disconnect
AURORA from both the AC and DC side and allow 5 minutes for the
internal capacitors to discharge.
To remove the front panel, remove the 4 screws as shown in Fig. 13 using the flat-
blade screwdriver.
Wind
frequency
input