User manual

User Manual Page 29 of 74

(PVI-6000-OUTD-UK-W Rev.1.0)

Fig.13 - AURORA with front panel

After replacing the front panel, tighten the screws to 1.5 Nm (13.2 in-lbs) to ensure

proper sealing.

3.9 Replacing the CR2032 lithium battery

WARNING: This component should only be replaced by qualified

personnel.

The AURORA inverter has a CR2032 lithium battery. When the battery is nearing the

end of its life, a corresponding message appears on the LCD display.

To replace the battery, remove the front panel (see Fig. 13) to get access to the battery

holder shown in Fig. 14.

Note that the battery will not fit

into its holder when pressed from the top down.

Instead, slide the battery into its holder from the side, while holding it tilted at a 30°

angle.

Fig. 14 - Battery in place