User manual

User Manual Page 4 of 74
(PVI-6000-OUTD-UK-W Rev.1.0)
USEFUL INFORMATION AND SAFETY STANDARD
INTRODUCTION
¾ The installation of AURORA must be performed in full compliance with national
and local standards and regulations.
¾ AURORA has no spare parts to replace.
For any maintenance or repair, please, contact the nearest authorized repair centre.
Please contact your reseller if you need to know the nearest authorized repair
facility.
¾ Read and understand all the instructions contained in this manual and become
familiar with the safety symbols in the relevant paragraphs before you install the
equipment
¾ The connection to the distribution grid must be done only after receiving approval
from the distribution utility as required by national and state interconnection
regulations, and can be done only by qualified personnel.
¾ The wind turbine need to be blocked with a mechanical brake prior to be
connected to AURORA to make sure that there is no voltage on the cable that can
result in a dangerous safety hazard.
GENERAL
During inverter operation, some parts can be powered, some not insulated and, in
some cases, some parts can move or rotate, or some surfaces be hot.
Unauthorized removal of the necessary protections, improper use, wrong installation
or wrong operation may lead to serious damage to people and objects.
Transport, handling, installation, commissioning and maintenance must be performed
by qualified and trained personnel (all relevant accident prevention rules must be
strictly observed)
According to these basic safety rules, qualified and trained people must possess skills
required for assembly, start-up and operation of the product, and have necessary
qualifications to perform such operations.