User manual

User Manual Page 43 of 74
(PVI-6000-OUTD-UK-W Rev.1.0)
4) Shows instant output voltage value and within/outside range status.
5) Shows instant output frequency value and within/outside range status.
6) If measured instant values of voltage (step 4) and frequency (step 5) are outside of
the allowed range, the following screens are shown alternately
-
Next connections (screen 3)
- Vgrid (screen 4)
- Fgrid (screen 5)
7) Instant value of isolation resistance
5.5.2 Error messages
After the connection is established, the inverter runs a test cycle. If wrong data are
found, the cycle is interrupted and an error code is displayed. Error codes and their
meaning are shown in the table in section 5.4
To modify the message shown in the display see the procedure in section 5.5.6.15
“Alarm Message”.
Until the error is removed, the following screens are shown alternately:
Once the error has been removed, the inverter resets all functions in progress and re-
starts the connection (Sect.5.5.1 Connection of system to the grid, item 2)
- Missing Grid
- Waiting Wind
Meas. Riso
……………………….
Fgrid 50,17 Hz
In ran
g
e
Vgrid 197,8 V
In ran
g
e
Custom msg………
Type OUTD
Part No………
S/N ………..……..
Firmware…………
ERROR
Code ……..