User manual

User Manual Page 44 of 74
(PVI-6000-OUTD-UK-W Rev.1.0)
5.5.3 First phase - electric parameter monitoring
A FEW POINTERS ON DISPLAY KEY OPERATION:
During regular operation, the display will cycle through available data. The display
shows a different screen every 5 seconds, screens may be scrolled manually by
pressing the UP and DOWN buttons next to the display.
Pressing the ESC key (right next to the display) calls back the previous menu.
Fig.20
Fig.21
Auto-scroll is indicated by 2 arrows in the top left corner of the display (Fig.20).
To stop auto-scroll, press the
ENTER button. A picture of the padlock will appear
(Fig.21).
1A) If the parameters measured previously (see sect. 5.5.1) are correct, the system will
proceed to the next checks. The 12 screens outlined below are shown alternately as
mentioned in section “A FEW POINTERS ON DISPLAY KEY OPERATION”.
2A) shows inverter serial number and firmware revision level.
3A)
E-tod : Daily energy output.
$-tod: Daily energy savings. Value is expressed in the set currency.
Type OUTD
PN------------
S/N--------- xxxxxx
FW rel. C.0.1.1
E-tod 0 Wh
$-tod 0.0 EU
R