User manual

User Manual Page 5 of 74
(PVI-6000-OUTD-UK-W Rev.1.0)
ASSEMBLY
Devices shall be assembled and cooled according to the specifications mentioned in
the corresponding documents.
In particular, during transportation and handling, parts shall not be bent and/or the
insulation distances shall not be changed. There should be no contact between
electronic parts and connection terminals.
Electrical parts must not be mechanically damaged or destroyed (potential health risk).
ELECTRICAL CONNECTION
With the inverter powered, comply with all national regulations on accidents
prevention.
Electrical connections shall be carried out in accordance with the applicable
regulations, such as conductor sections, fuses, PE connection, etc.
OPERATION
Systems with inverters shall be provided with further control and protective devices in
compliance with the corresponding safety rules, such as those relating to the
compliance with technical equipment, accident-preventing regulations, etc. Any
calibration change shall be made using the operational software. Once the inverter has
been disconnected from the power grid, powered parts and electrical connections shall
not be touched as some capacitors could be charged. Comply with all corresponding
marks and symbols present on each device. During operation, make sure that all covers
and doors are closed.
MAINTENANCE AND SERVICE
Comply with manufacturer’s recommendations.
SAVE ALL DOCUMENTS IN A SAFE PLACE!