User Guide

Torso 6 english
Heating in-between seasons
Heating the stove in between seasons, when the
outside temperatures are higher, the flue gases may
not be able to escape completely and this may lead to
disturbances in the chimney draught, especially if the
temperatures are rising suddenly. The stove has to
be charged with less wood and the primary air has to
be increased so that the wood can burn down faster
(with visible flames) and thus the chimney flue can
stabilize.
Chimney fire
A chimney fire may occur, due to sooting and
deposits in the chimney, if wrong or humid fuel is
used. Close all air inlets on the fireplace/chimney
immediately and call the fire brigade. Please have an
expert inspect your chimney for cracks and air-
tightness after the burning out of the chimney
.
4. THE MOST IMPORTANT SPARES—OVERVIEW
Gaskets
Description Nr. drawing Part number
Hollow round gasket 6 mm ( 2 m) 20 718183
Round gasket 12 mm (2,2 m) 21 710338
Flat gasket 8 x 2 mm (0,6 m) 23/24 710096
Keramott
Description Nr. drawing Part number
Torso bottom left, keramott 1 716354
Torso bottom right, keramott 2 716355
Grate 3 716408
Torso wood retainer, keramott 4 712642
Torso side component left, kermott 5 716645
Torso rear, keramott 6 716356
Torso baffle plate rear, keramott 7 716358
Torso baffle plate front, keramott 8 716357
Torso side component right, keramott 9 716646
Other parts
Description Nr. drawing Part number
Torso door glass 22 716376
Glass cleaner ½ litre -- 640070
Igniter -- 640162
Stove laquer -- 650002
Accessories
You can obtain floor plates made of glass or steel, hearth accessories or care products or the Heat
Memory System for heat storage from your certified dealer.
IMPORTANT: Have defective parts replaced by your certified dealer only. This will guarantee that your
stove functions properly and safely.
The fireplae must not be amended.
Maintenance
To clean the glass, please use a specialized product such as Thermohit glass cleaner. Lacquered
surfaces are to be cleaned only with a cloth (may be damp). Special cleaning agents should also be used
for stainless steel surfaces.
Cleaning
The stove, flue outlets and smoke pipes should be cleaned and inspected for deposits every year – if
necessary more often, e.g. after the cleaning of the chimney. The chimney also has to be cleaned regularly by
the chimneysweeper. Your chimneysweeper will inform you of the necessary inspection intervals. An expert
should inspect the stove annually.
Keramott numbering = installation instructions!