User Manual

35
4. Tap on the right side of the MIN button and enter the required
minimum value.
5. Tap on the right side of the MAX button and enter the required
maximum value.
6. Tap the ON/OFF button on the right side of the Buzzer Alarm button
to turn it on or off.
7. Tap Done to save the setting and return to the Live Data screen; or
tap Cancel to exit without saving.
If the threshold limits are successfully set, two horizontal lines will display on
each of the data graphs (when Waveform Graph Mode is applied) to indicate
the alarm point. The threshold lines are displayed in different colors from the
waveform of the parameters.
 Record Button – displays the configuration screen for Record Setting, to
set the trigger type, duration and trigger point for the data recording
function.
a) Trigger Type – sets the trigger mode for data recording, Manual and
Auto. There are four options available:
1) Manual – manually start and stop data recording.
2) DTC – auto triggers data recording when any DTC is detected.
3) DTC Check Mode – auto triggers data recording when certain
pre-selected DTC types are detected.
4) Parameter – auto triggers data recording when any parameter
value reaches the preset threshold.
b) Duration – sets the recording time (for Auto trigger mode only).
c) Trigger Point – reserves a relative percentage of a record length
before the data recording start point for reference (for Auto trigger
mode only).
 To perform setting for live data record
1. Tap the Setting functional button at the bottom of the Live Data
screen.
2. Tap the Record navigation button.
3. Tap the
○
> button on the right of Trigger Type bar and select the
required trigger mode.
4. Tap the
○
> button on the right of Duration bar and select a length