Installation guide

P. 10 Installation Guide CT-3400 TW
How to Program the Transmitter.
1. FLASH the Hood Pin Switch (see on page 9).
Before the 20 seconds have passed, turn the Ignition Key to the IGNITION ON (RUN) position
and then to the OFF position.
2. Press and hold the LOCK button until the vehicle gives 5 flashes. The Module has
stored the Transmitter in its memory.
3. Close the Hood, to exit.
Table 1
To program a Transmitter on the second vehicle for multi-car operation, you must press the
TRUNK button (instead of LOCK or UNLOCK) in step 3 of the transmitter programming procedure:
How to Enter Programming Options Mode
The System is equipped with two custom Programming Modes, allowing the installer to
custom-fit the system according to the requirements of each vehicle. When getting into the
Programming Option Mode, the Parking Lights will flash once, twice depending on the option
you have entered. The unit will stay in Programming Mode until the Hood Pin-switch or the
Brake Pedal is pressed again; therefore take your time to make the proper selection. To
return to the Programming Centre (Main Menu), press on the Brake Pedal.
1. FLASH the Hood Pin Switch (see on page 9).
Before the 20 seconds have passed,
2. Press and hold the Brake Pedal, then press one of the following buttons on the
Transmitter:
• LOCK to enter Mode 1;
• UNLOCK to enter Mode 2;
• TRUNK to enter mode 3;
• START/STOP to enter mode 4.
The Parking Lights and the Siren will flash and chirp once or twice to confirm entry
into a Mode.
3. Release the Brake Pedal.
Table 2
The Module can only be programmed Function by Function. After selecting a Mode (1
or 2), you will be taken to the first Function of that Mode. After entering an Option selection
for Function 1, you will be automatically taken to Function 2, and so on; therefore, be ready to
re-enter all option selections for all functions of the Mode you are accessing. You may not
skip Functions*.
*NOTE: Pressing the Brakes at any given moment will save the selection(s) you have entered
and will return you to the Programming Center.
For each Function, select one of the three Options by pressing the corresponding
button on the Transmitter:
• LOCK for Option 1,
• UNLOCK for Option 2,
• TRUNK for Option 3,
• START/STOP for Option 4,
• F → LOCK for Option 5.
Table 3