Installation guide

P. 14 Installation Guide CT-3400 TW
Horn Honk Timing
Follow these steps to program horn confirmation:
1. FLASH the hood pin (see on page 9).
The parking lights will stay on for up to 20 seconds.
2. Press the brake pedal.
3. Press the UNLOCK and START/STOP buttons; the horn will honk 5 times.
4. Release the brake pedal.
5. To adjust the chirp duration:
a. To increase the horn chirp by 3 ms, press the LOCK button.
b. To decrease the pulse by 3 ms, press the UNLOCK button.
c. To increase the pulse by 10 ms, press the START/STOP button
d. To decrease the pulse by 10 ms, press TRUNK.
For each timing change, the horn will chirp using the new settings, except under the
following circumstances:
• When the lower limit of 5 ms is reached, the horn will sound for 1/4 second.
• When the upper limit of 200 ms is reached, the horn will sound for 3/4 second.
• A system reset will set the system back to the 22-ms default.
• If you press LOCK and UNLOCK, 3 chirps will be generated to indicate that the new values were
saved.
Close the hood to cancel the changes.
Note
Horn honk timing can be modified only if Mode 3,
Function 2, Option 1 or 3 has been selected first.
Installation-programmable Features
The following features can be programmed according to the needs of the installation and the
requirements of the user:
Ignition Re-lock
When ignition is ON (but not under remote start) and a door is opened and closed, the system will
re-lock all doors next time the brake pedal is pressed.
Lock Pulse Duration
Option 1: 7/10-sec. LOCK and 7/10-sec. UNLOCK pulses by default.
Option 2: 4-sec. LOCK/UNLOCK pulses–this is for operating vacuum Door Lock systems.
Option 3: A single 7/10-sec. LOCK pulse and two ¼-secs UNLOCK pulses.
Used for double-pulse Disarm/Unlock systems
Option 1: 1/10-sec. LOCK and 1/10-sec. UNLOCK pulses.
Flashing LED
To gain access to this feature, make sure the Flashing LED option has been enabled at
the time of programming. Once this option is enabled, the user has the choice to toggle
the Flashing LED “ON” and “OFF” at any given moment.
To toggle between the Flashing LED “ON” and “OFF”, press
LOCK and UNLOCK
simultaneously on the Transmitter. The parking lights will flash 1 time slowly to indicate
that the LED is active. If you press
LOCK and UNLOCK once more, the parking lights will
flash 3 times quickly to show that the LED is now disabled.