Installation guide

CT-3400 TW Installation Guide P.15
• Flashing LED ON: The LED will flash at all times (being passive or active
arming) to denote that the Starter Kill is active.
• ACTIVE Arming: the LED flashes normally.
• PASSIVE Arming: the LED will flash, during the countdown, at a faster rate
until the Unit is armed, at which time the flashing rate will slow
down.
• In Valet Mode, the LED will be on solid.
• Flashing LED OFF: The LED will not flash when the module is armed (passive
or active arming). However, if the module is in Valet Mode, the LED will remain
on solid when the Ignition is “OFF”.
Engine Type – Gas or Diesel
Set to Gas Mode by default, the unit can be programmed to operate in Diesel Mode. In Diesel
Mode the system will wait for the glow-plug indicator light to go out before cranking the engine.
Note that the run time is automatically extended when Diesel Mode is selected.
Horn Confirmation
AUX 1 can be programmed to trigger the horn every time the LOCK button is pressed, or when the
LOCK button is pressed twice within 3 seconds. When horn confirmation is activated, panic mode is
enabled. If horn confirmation is disabled, panic mode will not be available.
Safe Start
If this feature is enabled, it will require the user to press the START/STOP button twice within 3
seconds to start the vehicle. This will eliminate accidental remote starts (for example: if there are
children playing with the transmitter). To stop the vehicle, the user must press
START/STOP once. If
swap start mode is selected, to remote-start your vehicle, press the
‘F’ button and then the LOCK
button. The
Aux 2 output can be activated by pressing the START/STOP button.
Idle Mode
When programmed, this option allows the user to engage the remote starter to take over the vehi-
cle while it is already running. This will keep the vehicle running for its programmed run time, or
until it is shut down.
To activate Idle Mode:
1. While the Engine is running, press LOCK, UNLOCK or START/STOP on the transmitter until the
parking lights come on.
• Pressing LOCK or UNLOCK will unlock the doors.
• Pressing START/STOP will leave the doors as they are.
2. Remove the ignition key and exit the vehicle.
3. Lock the doors – the vehicle will go on running for the entire pre-programmed run time.
Caution: Do not leave children or pets unattended in a vehicle running in Idle Mode!!!
Turbo Mode
When programmed, this option allows turbochargers to idle down: after the user leaves the vehicle,
the engine will keep running for 60 sec. and shut down.
Proceed as follows to activate Turbo Mode:
1. With the engine already running press LOCK on the transmitter until the parking lights come
on.
2. Remove the key: the engine will go on running.
3. Exit the vehicle and close the door.