Installation guide
CT-3400 TW Installation Guide P.21
Diagnostics (Parking Lights)
Parking light flash rate (normal operation)
Flashes Description
1
• Doors locked, starter kill armed.
• Run time has expired.
•
TRUNK button pressed.
• Start signal received by the module.
• Cold weather mode cancelled.
• Enabling LED.
2
• Remote start attempt cancelled by remote.
• Doors unlocked, starter kill disarmed.
• Exiting remote valet
• Exiting ignition valet
• Power-up reset
3
• Entering cold weather mode.
• Entering remote valet.
• Entering ignition valet.
• Entering extended run time.
• Disabling LED.
3 slow flashes… …after a failed start attempt The module did not detect a tach signal.
4
• +12 V detected on the brake input wire either while cranking or during run time.
• Entering multi-speed tach programming.
5 Slow • Start attempt failed because no tach signal has been programmed.
5 Fast
• Tach signal programmed.
• New transmitter programmed.
6 • A remote start was attempted while a tach-before-crank signal was detected before cranking.
8 • Unit reset see “Resetting the Module”
10 • A ground (-) signal was detected on the hood pin input wire.
1 pause
1pause
5 flashes
[During the transmitter programming procedure]
• Transmitter has been programmed.
1 – pause – 2
• There was a remote start attempt while the vehicle was in valet mode.
• Failed start: vehicle’s low battery voltage.
2 – pause – 2 • There was an attempt to start the vehicle while the module was in home valet mode.
…followed by 1 flash Exiting cold weather mode
ON SOLID for 3
seconds….
…followed by 3 flashes Entering cold weather mode
ON continuously • Idle mode: Idle mode is engaged
• Run time: The vehicle has been remote started and is in run time.
ON continuously While the brake pedal is pressed. • Confirms that cold weather mode is engaged
ON 2 seconds • The hood has been opened and a ground (-) signal has been detected on the hood pin input wire.
ON 4 seconds • Locking or unlocking a door (with Door pulses configured to 4 sec.)
ON 20 seconds • The hood pin has been flashed and you now have access to the programming options.
Constant flashes
up to 25 sec.
• Panic mode is triggered.