Installation guide

CT-3400 TW Installation Guide P.29
¾ Turn the key Off, On, Off then keep pressing the LOCK button repeatedly until you get
5 light flashes from the module.
The entire process should take less than 20 seconds.
2. Won't start by remote
• Does the light on the remote light up when you press the button?
• Is the starter in valet mode?
• Does the vehicle have passive antitheft security (PATS, VATS, PASSLOCK,
TRANSPONDER)?
3. The car cranks for 8 seconds but won't start.
• Are you on the correct ignition wire?
• Does the car have more then 1 ignition?
4. The car cranks briefly then quits.
• Have you bypassed the passive security? (PASSLOCK, PASSKEY III, PATS...)
• Have you adjusted tach?
• Is the vehicle's battery weak?
5. The park lights come on for 8 seconds but will not crank
• Does the car have an after market starter kill?
• Have you bypassed the VATS or Passlock II?
• Is the start wire hooked up correctly?
• Has the clutch been bypassed properly (for standard transmissions)?
6. The car starts but starter stays engaged
• Make sure ignition and crank are not common with the key out (connected at rest). May
have to add relay (i.e. Tercel, Altima)
• Did you make an Auto Tach Adjustment?
• Weak Tach signal?
• Bad ground?
7. The car starts by remote fine then the starter re-engages
• Check ground wire
• Is Tach programmed?
8. The car starts on it's own
• Is the module in cold weather mode?
• Program remote 4 times. (another remote may be programmed to your module)
• Is external trigger shorting out to ground?
9. I get one long flash when I press the button trying to go into ready mode.
• Check tach circuit.
10. The factory alarm goes off when I start by remote.
• Did you hook the disarm wire?
• Do you have the correct OEM disarm wire?
• Did you program the disarm wire? (CT-3100/3160 only)
11. The ABS, Check Engine light come on in the dash.