Installation guide

P. 8 Installation Guide CT-3400 TW
and the negative Glow-plug wire of the car. This is to prevent feedback effects
on the Glow-plug indicator light on the instrument cluster: the light on the dash
would come on because of the feedback, even though the circuit is off.
When the user remote-starts the vehicle:
• The Remote Car Starter will power up the Ignition circuit and wait to
engage the Starter Motor while the Glow-plug indicator light is still on.
• The Remote Car Starter will engage the Starter Motor as soon as the
Glow-plug light (+) goes out.
o Minimum waiting time is 3 seconds.
o Maximum waiting time is 18 seconds.
If no Glow-plug wire is found on the vehicle, the Glow-plug input on the
Remote Car Starter may be “timed out”. The Remote Car Starter will power
up the Ignition and Glow-plug circuits and simply wait for the time-out before
starting:
• Connecting the Glow-plug input wire of the Remote Car Starter to
Ignition will hold the ignition ON for the maximum waiting time (18 sec.,
recommended).
• Keeping the Glow-plug input wire of the Remote Car Starter
unconnected will hold the ignition ON for the minimum waiting time (3
sec., not recommended in very cold environments).
Connect the Glow-plug wire to the Ignition wire only after the Tach
programming has been completed: connecting the Glow-plug wire is one of
the very last steps in the installation process.
2-Pin Harness
Wire Description
2 BLUE / WHITE
This output will provide a 1-sec. negative output (500 mA) when the
UNLOCK button is pressed a second time on the transmitter (priority door
access) or otherwise when the LOCK button is pressed (horn
confirmation).
3
YELLOW
(-) Parking Light
output
500 mA negative Parking Light output
Note: Ensure that the voltage does not vary when the dimmer control
switch is turned up or down. If this is the case, it is not the right wire.
There is a also a positive Parking Light output. Only one of
these two different outputs needs to be connected.
Flashing the Hood Pin
What is Flashing the Hood Pin?
It is a procedure that makes the module enter the programming centre. Once the module is
in the programming centre, the installer has no more than 20 seconds to get into one of the
sub-menus. Failure to do so will result in the module exiting the programming centre
and the installer will have to flash the hood pin once more.
Remember: You can use the programming
assistance button instead of the hood pin at any time
the hood is up.