Installation guide

CT-3400 TW Installation Guide P.9
The Installer … The Module …
1- Press and hold the hood pin for 4 seconds.
2- Let go of the hood pin.
Parking lights “ON”
3- While the parking lights are “ON”, press down the hood
pin once more.
4- Release the hood pin again —be careful not to over
flash the hood pin as this will bring up the events
playback and will not bring you the programming
centre.
“ON” for 20 seconds
5- You now have 20 seconds to select one of the sub-
menus.
Once inside the programming centre, the installer has a selection of many different sub-
menus. Once you are in the programming centre, you have the option of the following
menus:
a) Transmitter Programming ………………….. p.10
b) Programming Options…………………..… p.11
c) Honk Horn Timing* (*if available) ………..… p.14
d) Tach Programming …………………..……… p.13
Remember: You have up to 20 seconds, once the parking lights are on solid, to select a sub-
menu, Failure to do so will result in the module exiting the programming centre and the installer
will have to flash the hood pin once more.
The Programming
Assistance Button
(a.k.a. PAB)
The PAB is located on the
side of the Module. This
push button mimics the
Hood-Pin switch in order
to avoid having to get out
of the vehicle and
pressing the Hood-Pin
switch. The PAB will
work only when the
hood is up.
Before Programming a Transmitter
The Transmitter is not delivered pre-programmed: it must be programmed after the wiring of
the Module is completed.
The Module has the ability to retain up to 4 different Transmitter codes; if a fifth Transmitter is
programmed, the code of the first Transmitter will be erased from memory.