Instruction manual

Circulation operation mode
1) Press the MODE button in a sequence until the fan indicator lights up.
2) Press the FAN button to choose the fan speed (low-med-high)
3) Do not put the duct to the window.
4) Press the ON/OFF button to start the unit and press it again to stop.
Timer operation
1) Press the TIMER ON or TIMER OFF button to initiate the auto-on or auto-off
sequence.
2) Press the UP or DOWN button to set your desired wait time. Each press will
increase or decrease one hour.
Wind direction adjustment
Horizontal airflow (automatic)
Press the SWING button, the vertical vanes rotate automatically. If you have
a desired direction, you also can press it again to stop at the position.
Vertical airflow(manual)
Grab and rotate the middle horizontal vane manually.
Note: Adjusting the vertical vane by hand in automatically-controlled operation
May damage the step-motor.
.
Continuous drainage
1) Drain water can be collected externally
by directing the plastic tube(inner
diameter:12mm~12.5mm) inside the
drain tank cabin through the water tank
to any vessel such a bucket. Remove
the plastic tube cap before operating.
2.Do not take out the water tank during drainage.
IMPORTANT: This water is not suitable for drinking.
8
Note: The timer operation in the control panel differs from the remote control.
Deal with condensation
Condensation in the water tank
2) Carefully remove the water tank from the cabinet and dispose of the water.
Replace the water tank back to its original position and the dehumidifying
process will automatically resume. It will take 3 minutes for the compressor
to restart. This is normal.
.
1) When the water tank is full, the dehumidification process will immediately
stop. However the fan motor will continue to operate for two minutes, then
the LED will display PI and the unit will alarm, at the same time the water
full indicator light will flash continuously.