Instruction manual

You can solve many common air conditioner problem easily, saving you the
cost of a service call, try the suggestions below to see if you can solve your
problem without outside help.
Causes
Solutions
Power switch is released.
Power supply failure.
The fuse is burnt.
It doesn't reach the set time for start
up.
Switch on the power.
Wait for power to be restored.
Replace the fuse.
Wait or eliminate the original setting.
Causes
Solutions
Unit Doesn't Start When Pressing On/off Button
Water full indicator flashing, drain
tank is full.
Room temperature is lower than the
set temperature.
Dump the water in the drain tank.
Reset the temperature.
Troubleshooting
Air Conditioning will not operate
2) Wipe the unit with a dry cloth .
3) If the unit is very dirty, wet the cloth with cold water .
Never use hot water over 40 to clean the air filter.
Do not use gasoline ,benzene ,thinner or any other chemicals, or any liquid
insecticide on the air conditioner, as these substances may cause flaking off of
the paint ,cracking or deformation of plastic parts .
Never attempt to clean the unit by pouring water directly over any of the
surface areas, as this will cause deterioration of electrical components and
wiring insulation.
Cleaning drain tank
Wash the tank using warm water and a
neutral detergent. Rinse and then dry in
a cool place. Put the tank in its original
place after it has dried completely.
12