Instruction manual

Function Buttons
SLEEP button
Press this button to set the sleep state.
TIMER ON/OFF button
Press this button to initiate the auto-on or auto-off time sequence .
MODE button
Each time you push the button, a mode is selected in a sequence that goes
from cool, dry and fan.
FAN button
This button is used for setting fan speed in the sequence that goes from
Low Me to Hig then back to Low.
SWING button
Press the button to change the swing angle of louver.
UP button
Push the button to make the indoor setting temperature increase.
DOWN button
Push the button to make the indoor setting temperature decrease.
ON/OFF button
To turn the unit on or off the unit.
Before starting the unit
1) Select a suitable location, making sure you have easy access to an electrical
outlet.
2) Install the flexible exhaust hose and the adjustable window slider kit.
3) Plug the unit into a 220V-240V socket.
4) Make sure the water tank is correctly positioned inside the cabinet otherwise
the unit will not operate.
5) To turn the unit on press the ON/OFF button.
Cooling operation mode
1) Press the MODE button in a sequence until the cool indicator lights up.
2) Press the UP and DOWN button to adjust your desired set temperature.
3) Press FAN button to select the fan speed.
4) Press the SWING button to change the airflow direction.
5) Press the ON/OFF button to start the unit and press it again to stop.
Operation
Note :The functions of these buttons are the same on the remote control.
7
Dehumidifying operation mode
1) Press the MODE button in a sequence until the dry indicator lights up.
2) The fan will run at a fixed speed at this operation mode.
3) Close windows and doors for the best dehumidifying effect.
4) Do not put the duct to the window.
5) Press the ON/OFF button to start the unit and press it again to stop.