User's Manual

Configuring GRE, NAT, RIPSO, and BFE Services
2-56
308625-14.00 Rev 00
Using the BCC
To configure N-to-1 translation:
1.
Configure a local address range (see “Adding a Local Address Range” on
page 2-43).
2.
Navigate to the local address range prompt (for example,
box; ip; nat;
local-range/10.1.10.0/24
) and enter:
n-to-1 <global_address>
global_address
is the IP address to be used in this N-to-1 translation entered
in dotted-decimal notation.
For example, the following command sequence configures the IP address
199.1.42.100 as the global address for the local address range 10.1.10.0/24 and
verifies the entry:
local-range/10.1.10.0/24# n-to-1 199.1.42.100
local-range/10.1.10.0/24# info
start-address 10.1.10.0
prefix-length 24
n-to-1 199.1.42.100
type n-to-1
state enabled