User's Manual

Configuring GRE, NAT, RIPSO, and BFE Services
4-6
308625-14.00 Rev 00
Outgoing SVC LCN Start Parameter is ignored.
Number of PVC channels Zero (0). BFE does not support PVCs.
PVC LCN Start Parameter is ignored.
T1 Timer, T2 Timer, T3 Timer,
T4 Timer
BFE has no special requirements for any of these four
parameters.
Flow Control Negotiation Set to on if you do not want to use the default values
configured in the BFE for this link.
Max Window Size Range is 2 to 7. If you specify any setting other than the
default value configured in the BFE, set Flow Control
Negotiation to on. This value should be coordinated with
the X.25 service record value.
Max Packet Length Options include 128, 256, 512, and 1024. If you specify
any value other than the default value configured in the
BFE, then set Flow Control Negotiation to on. (If the IP
interface is configured to support multiple IP security
levels, then set to 1024.) This value should be
coordinated with the X.25 service record value.
Trans/Recv Throughput Class Parameter is ignored.
Max Throughput Class Parameter is ignored.
Throughput Class Negotiation Off
Network User Identification Off
Incoming Calls Accept On
Outgoing Calls Accept On
Fast Select Accept Off
Reverse Charge Accept Off
Fast Select Off
Reverse Charging Off
CUG Selection Null
CUG Outgoing Access Null
CUG Bilateral Selection Null
RPOA Selection Off
Charging Information Off
Transit Delay Off
(continued)
Table 4-1. BFE X.25 Packet-Level Parameter Settings
(continued)
Parameter Setting