User's Manual

Configuring GRE, NAT, RIPSO, and BFE Services
A-8
308625-14.00 Rev 00
To access the NAT Base Group Record window, complete the following tasks:
Site Manager Procedure
You do this System responds
1. In the Configuration Manager window,
choose
Protocols
.
The Protocols menu opens.
2. Choose
IP
. The IP menu opens.
3. Choose
NAT
. The NAT menu opens.
4. Choose
Global
. The NAT Base Group Record window
opens.
Parameter: Enable
Path: Configuration Manager > Protocols > IP > NAT > Global
Default: Enable
Options: Enable
|
Disable
Function: Enables or disables NAT on the router. If enabled, NAT will perform network
address translation. If disabled, no network translation occurs.
Instructions: Set to Enable to enable NAT on the entire router. Set to Disable to disable NAT.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.7.1.2
Parameter: Soloist Slot Mask
Path: Configuration Manager > Protocols > IP > NAT > Global
Default: All slots (except for slot 1)
Options: One or more slot numbers specified using a bit mask
Function: Specifies the slots on which NAT can run as a soloist.
Instructions: Set the bits on the soloist slot mask by entering a 1 in the correct bit position in
the mask. The leftmost bit represents the slot with the lowest number. For
example, if a router has five slots, you can configure a slot mask to allow NAT to
run as a soloist on slots 3 and 5 by entering the binary value 00101.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.7.1.4