User's Manual

Configuring Network Address Translation
308625-14.00 Rev 00
2-17
Where to Go Next
The instructions provided in “Starting NAT Services” are the minimal instructions
required to enable NAT operation with dynamic address translation on your router.
You can configure other types of address translation--static or N-to-1--or further
customize NAT operation.
Use the following table to determine where to go next.
12. Choose
NAT
. The NAT menu opens.
13. Choose
Dynamic
. The NAT Dynamic menu opens.
14. Choose
Global.
The NAT Global Address Range List
window opens.
15. Click on
Add
. The NAT Global Address Range Add
window opens.
16. Set the following parameters:
• IP Address
• Prefix Length
Click on
Help
or see the parameter
descriptions beginning on page A-20.
17. Click on
OK
. You return to the NAT Global Address
Range List window.
18. Click on
Done
. You return to the Configuration Manager
window.
If you want to Go to
Start NAT synchronization. “
Starting NAT Synchronization” on page 2-18
Configure static address
translation.
“Configuring Static Address Translation” on page
2-38
Configure N-to-1 address
translation.
“Configuring Network Address Port (N-to-1)
Translation” on page 2-53
Change default settings for NAT
global parameters.
“Customizing NAT Global Parameters” on page 2-22
Change default settings for NAT
interface parameters.
“Customizing a NAT Interface” on page 2-31
Site Manager Procedure
(continued)
You do this System responds