User's Manual

Configuring GRE, NAT, RIPSO, and BFE Services
2-20
308625-14.00 Rev 00
Configuration Example
The following example shows the BCC commands that you enter to configure
NAT synchronization using an already configured IP interface as the synchronized
router ID:
box#
ip; nat
nat#
synch enabled
nat#
peer 10.0.0.20 address 10.0.0.20
Using Site Manager
You must configure an IP interface on the router before enabling NAT
synchronization. If an IP interface already exists, you will be prompted to select
that interface as the synchronized router ID.
Enabling NAT Synchronization
To enable NAT synchronization, complete the following tasks:
Site Manager Procedure
You do this System responds
1. In the Configuration Manager window,
choose
Protocols
.
The Protocols menu opens.
2. Choose
IP
. The IP menu opens.
3. Choose
NAT
. The NAT menu opens.
4. Choose
Global
. The NAT Base Group Record window
opens.
5. Set the
Synchronization
parameter to
Enable
. Click on
Help
or see the
parameter description on page A-10.
6. Click on
OK
. You are prompted to accept a configured
IP interface as the synchronized router
ID.
7. Do one of the following:
• To accept the IP address as the
synchronized router ID, click on
Yes
.
• To specify a different router ID, click on
No
and set the
Synch Router ID
parameter. Then click on
OK
.
You return to the Configuration Manager
window.