User's Manual

Configuring Network Address Translation
308625-14.00 Rev 00
2-45
Enabling and Disabling a Local Address Range
When you add a local address range, it is enabled by default. You can use the BCC
or Site Manager to disable or reenable it.
Using the BCC
To disable or reenable a local address range, navigate to the local address range
prompt (for example,
box; ip; nat; local-range/10.1.10.0/24
) and enter:
state
<state>
state
is one of the following:
enabled
(default)
disabled
For example, the following command sequence disables the local address range
10.1.10.0/24 and verifies the change:
local-range/10.1.10.0/24#
state disabled
local-range/10.1.10.0/24#
info
start-address 10.1.10.0
prefix-length 24
n-to-1 0.0.0.0
type 1-to-1
state disabled