Wireless AP-3 User's Guide

Recovery Procedures
Avaya Wireless AP-3 User’s Guide 7-29
5. Enter show ip. Result: Network parameters appear:
Figure 7-2. Result of “show ip” CLI Command
6. Change the IP address and other network values using set and
reboot CLI commands, similar to the example below (use your
own IP address and subnet mask). Note that IP Address Type is
set to Dynamic by default. If you have a DHCP server on your
network, you should not need to manually configure the
Access Point’s IP address; the Access Point will obtain an IP
address from the network’s DHCP server during boot-up.
Result: After each entry the CLI reminds you to reboot; however
wait to reboot until all commands have been entered.
[Device name]> set ipaddrtype static
[Device name]> set ipaddr <IP Address>
[Device name]> set ipsubmask <IP Subnet Mask>
[Device name]> set ipgw <Default Gateway IP Address>
[Device name]> show ip (to confirm your new settings)
[Device name]>
reboot 0