Multiservice Wan Access Router Module User's Guide

Chapter 6 X330WAN CLI Commands
100 Avaya X330WAN User’s Guide
Example
• To add an entry to the SNMP trap receiver table:
X330WAN-2DS1-1(super)# set snmp trap 192.168.173.42
SNMP trap receiver added.
• To enable SNMP vlan_violation traps to a specific manager:
X330WAN-2DS1-1(super)# set snmp trap 192.168.173.42 enable
vlan_violation
SNMP vlan_violation change traps enabled.
• To enable all traps to a specific manager:
X330WAN-2DS1-1(super)# set snmp trap 192.168.173.42 enable all
All SNMP traps enabled.
•To disable SNMP vlan_violation traps to a specific manager:
X330WAN-2DS1-1(super)# set snmp trap 192.168.173.42 disable
vlan_violation
SNMP vlan_violation traps disabled.
set snmp trap auth
Use the set snmp trap auth commands to enable/disable the sending of SNMP
traps upon SNMP authentication failure.
Syntax
set snmp trap {enable|disable} auth
Example
X330WAN-2DS1-1(super)# set snmp trap enable auth
Authentication trap enabled
set snmp trap enable frame-relay
Use the set snmp trap enable frame-relay command to enable the DLCI link
state SNMP traps. The traps are disabled by default.
Syntax
set snmp trap enable frame-relay
Example
X330WAN-2DS1-1(super)# set snmp trap enable frame-relay
vlan_violation
(Optional) Specify the VLAN violation trap from the TRAP-
MIB.