Multiservice Wan Access Router Module User's Guide

Console (RS232) Interface CLI Commands
Avaya X330WAN User’s Guide 111
interface Console
Use the interface Console command to enter the Console interface (interface
console
context) to PPP configure mode. For LAN interfaces, use this command to
create the interface. The
no form of this command sets the default Console
parameters.
Syntax
[no] interface Console
Example
X330WAN-2DS1-1(configure)# interface Console
ppp authentication (Console interface context)
Use the ppp authentication command to set the type of password that should be
sent for authentication, if necessary.
Syntax
ppp authentication {pap|chap|none}
Parameters
Example
To select the CHAP authentication protocol:
X330WAN-2DS1-1(config-if:CON)# ppp authentication chap
speed (Console context)
Use the speed command to set the PPP baud rate to be used by asynchronous PPP
ports.
Note:
1. This command is executed from the Console interface.
2. The peer baud-rate must be set to the same value.
Syntax
speed {9600|19200|38400}
pap
Password Authentic Protocol. Unencrypted password sent for authentication.
chap
Challenge Handshake Authentication Protocol. Encrypted password sent for
authentication.
none
No password sent.