Multiservice Wan Access Router Module User's Guide

Controller CLI Commands (X330WAN-2DS1 Only)
Avaya X330WAN User’s Guide 123
loopback diag (Controller context)
Use the loopback diag command to put the T1 or E1 line into loopback mode.
Note: Use this command during line setup and maintenance.
Note: Only one type of loopback can be defined at any given time.
Syntax
loopback diag
loopback local (Controller context)
Use the loopback local command to put the T1 or E1 line into loopback mode.
Note: Use this command during line setup and maintenance.
Note: Only one type of loopback can be defined at any given time.
Syntax
loopback local {line|payload}
Parameters
Example
X330WAN-2DS1-1(config-controller:1)# loopback local line
line
The controller loops the external line signal back towards the
network without reframing the DS1 signal.
payload
The controller loops the external line signal back towards the
network and reframes the DS1 signal.