Multiservice Wan Access Router Module User's Guide

Chapter 6 X330WAN CLI Commands
132 Avaya X330WAN User’s Guide
Parameters
Example
X330W-2USP-1(super-if:Serial2)# idle-character marks
ignore-dcd (X330WAN-2USP Serial interface context)
Use the ignore-dcd command to configure the serial interface to monitor the
DSR/CTS signals instead of the DCD signal as the line up/down indicator. The
no
form of this command restores DCD monitoring as the line status indicator
(default).
Syntax
[no] ignore-dcd
Example
X330W-2USP-1(super-if:Serial2)# ignore-dcd
interface Serial (X330WAN-2DS1)
Use the interface Serial command to create and/or enter interface Serial
context. For LAN interfaces, use this command to create the interface. The
no form
of this command deletes an IP interface.
Syntax
[no] interface Serial <if-number>[<if-link-type>]
Parameters
flags
Flags are transmitted to indicate an idle line. This is the default.
marks
Marks (all ones) are transmitted to indicate an idle line.
if-number
Comprised of: port:channel-group[.ip-interface|sub-
interface[.ip-interface]].
• port The controller number (port number) for this serial port. For
the X330W-2DS1, this value is either 1 or 2.
•
channel-group An integer. For E1, between 0 and 30; for T1, between 0 and 23.
•
ip-interface The IP interface number within this interface (as a number of IP
interfaces might be bound to a Layer 3 interface). An integer
from 0 to 1024.
if-link-type
Point-to-point.