Multiservice Wan Access Router Module User's Guide

Chapter 6 X330WAN CLI Commands
144 Avaya X330WAN User’s Guide
Parameters
Example
X330W-2USP-1(super-if:Serial2.1)# frame-relay interface-dlci 20
frame-relay lmi-type (Serial interface context)
Use the frame-relay lmi-type command to set the type of LMI to be used. The
no form of this command sets the LMI to the default value AutoSense, for
automatically determining the LMI type.
Syntax
[no] frame-relay lmi-type <lmi-type>
Parameters
Example
X330W-2USP-1(super-if:Serial2)# frame-relay lmi-type AutoSense
Note: Choosing the disable option results in no LMI being used. This is equivalent
to setting no keepalive within the Serial interface context.
frame-relay lmi-n391dte (Serial interface context)
Use the frame-relay lmi-n391dte command to set the full status polling
counter. The
no form of this command sets the polling counter to the default value
(6).
Syntax
[no] frame-relay lmi-n391dte <polling-counter>
Parameters
Example
X330W-2USP-1(super-if:Serial2)# frame-relay lmi-n391dte 20
DLCI number
The DLCI number, an integer from 16 to 1007.
lmi-type
The LMI type, either AutoSense, ansi, q933a, lmi-rev1, or
disable
. The default is AutoSense.
polling-counter
The number of partial status enquiries, an integer from 1 to 255.