Multiservice Wan Access Router Module User's Guide

Frame Relay Configuration CLI Commands
Avaya X330WAN User’s Guide 145
frame-relay lmi-n392dte (Serial interface context)
Use the frame-relay lmi-n392dte command to set the LMI error threshold. The
no form of this command sets the error threshold to the default value (3).
Syntax
[no] frame-relay lmi-n392dte <threshold>
Parameters
Example
X330W-2USP-1(super-if:Serial2)# frame-relay lmi-n392dte 6
frame-relay lmi-n393dte (Serial interface context)
Use the frame-relay lmi-n393dte command to set the monitored event count.
The
no form of this command sets the monitored event count to the default value
(4).
Syntax
[no] frame-relay lmi-n393dte <events>
Parameters
Note: Set the value for this counter greater than the lmi-n392dte value.
Example
X330W-2USP-1(super-if:Serial2)# frame-relay lmi-n393dte 8
frame-relay priority-dlci-group (Serial sub-interface context)
Use the frame-relay priority-dlci-group command to define a priority group
of DLCIs on a sub-interface. The
no form of this command deletes the priority group
of DLCIs on the sub-interface.
Syntax
[no] frame-relay priority-dlci-group <DLCI1> [<DLCI2> [<DLCI3>
[<DLCI4>]]]
threshold
The error threshold value, an integer from 1 to 10.
events
The monitored error count value, an integer from 1 to 10.