Multiservice Wan Access Router Module User's Guide

Chapter 6 X330WAN CLI Commands
164 Avaya X330WAN User’s Guide
Layer 3 CLI Commands
This section contains a list of all Layer 3 related CLI commands.
arp
Use the arp command to add a permanent entry to the Address Resolution
Protocol (ARP) cache. The
no form of this command removes an entry, either a
static entry or a dynamically learned entry.
Syntax
[no] arp <ip-address> <mac-address>
Parameters
Example
To add a permanent entry for station 192.168.7.8 to the ARP cache:
Router (configure)# arp 192.168.7.8 00:40:0d:8c:2a:01
To remove an entry from the ARP cache for the station 192.168.13.76:
Router (configure)# no arp 192.168.13.76
arp timeout
Use the arp timeout command to configure the amount of time that an entry
remains in the ARP cache. To restore the default value, 14400, use the
no form of this
command.
Syntax
[no] arp timeout <seconds>
Parameters
Example
To set the ARP timeout to one hour:
X330WAN-2DS1-1(configure)# arp timeout 3600
To restore the default ARP timeout:
Router-N(configure)# no arp timeout
ip-address
IP address, in dotted decimal format, of the station.
mac-address
MAC address of the local data link.
seconds
The amount of time, in seconds, that an entry remains in the ARP
cache. Maximum value is 604800.