Multiservice Wan Access Router Module User's Guide

Chapter 6 X330WAN CLI Commands
182 Avaya X330WAN User’s Guide
Syntax
[no] ip proxy-arp
Example
X330WAN-2DS1-1(configure)# no ip proxy-arp
ip redirects (Interface context)
Use the ip redirects command to enable the sending of redirect messages on
the interface. The no form of this command disables the redirect messages. By
default, sending of redirect messages on the interface is enabled.
Note: This command is executed from the Serial, Fast Ethernet, and
FabricFastEthernet interfaces.
Syntax
[no] ip redirects
Example
X330WAN-2DS1-1(super-if:FastEthernet1)# ip redirects
ip rip authentication key (Interface context)
Use the ip rip authentication key command to set the authentication string
used on the interface. The no form of this command clears the password.
Note: This command is executed from the Serial, Loopback, Fast Ethernet, and
FabricFastEthernet interfaces.
Syntax
[no] ip rip authentication key <password>
Parameters
Example
X330WAN-2DS1-1(configure)# ip rip authentication key hush-hush
password The authentication string for the interface. Up to 16 characters are
allowed.