Multiservice Wan Access Router Module User's Guide

Policy CLI Commands
Avaya X330WAN User’s Guide 209
traceroute
Use the traceroute command as a trace route utility.
Syntax
traceroute <host>
Parameters
Example
X330WAN-2DS1-1(super)# traceroute 192.168.50.13
Policy CLI Commands
This section contains a list of all Policy-related CLI commands.
ip access-default-action
Use the ip access-default-action command to set the default action for a
specific Policy list.
Syntax
ip access-default-action <policy-list-number> <default-action>
Parameters
Example
X330WAN-2DS1-1(super)# ip access-default-action 101 default-action-
deny
ip access-group (Interface context)
Use the ip access-group command to activate a specific Policy list and direction.
The
no form of this command suspends the Policy list.
Note: This command is executed from the Serial, Loopback, Fast Ethernet, and
FabricFastEthernet interfaces.
host
The IP address.
policy-list-number
An integer from 100 to 149, where 0 is the default list.
default-action
default-action-deny|default-action-permit