Multiservice Wan Access Router Module User's Guide

Avaya X330WAN User’s Guide 17
Chapter 3
Initial Configuration
This chapter describes the initial configuration of the X330WAN, and includes the
following sections:
• Configuring the X330WAN - Describes how to configure an X330WAN Fast
Ethernet, FabricFast Ethernet, E1/T1, USP, or Loopback interface, and which
commands to use to display and save your configuration.
• X330WAN Default Settings - Lists the default settings of the X330WAN.
Configuring the X330WAN
X330WAN can be configured using the Command Line Interface (CLI) utility, the
built-in Avaya P330 Device Manager (Embedded Web), or Avaya MultiService
Network Manager (MSNM
™).
For instructions on using the CLI, refer to Chapter 6: X330WAN CLI Commands. For
instructions on using the Device Manager or Avaya MultiService Network
Manager
™, refer to the Avaya MultiService Network Manager or P330 Device
Manager User’s Guide on the Documentation and Utilities CD.
The CLI is command-line driven and does not have any menus. To activate a
configuration option, type the desired command at the prompt and press Enter.
This section describes how to do the following using the CLI:
• Establish a console and modem connection.
• Configure an X330WAN Loopback, Fast Ethernet, FabricFast Ethernet, E1/T1,
and USP interface.
• Check and save your configuration.
• Establish a Telnet session.
Establishing a Console Connection
Perform the following steps to connect a terminal to the Console port of the
X330WAN module for configuration of WAN parameters using the CLI:
1 Use the supplied cable to attach the RJ-45 console connector to the Console port
on the X330WAN module. Connect the DB-9 connector to the serial (COM) port
on your PC/terminal.
2 Use the following port settings on the terminal:
— Baud Rate - 9600 bps
— Character Size - 8