Use and Care Manual

www.factorybuysdirect.com
5160946-01A
Figure 2 - Attaching Double Burner
Assembly to Tank Bracket
Figure 1 - Attaching Single Burner
Assembly to Tank Bracket
OPERATION
Burner Head
Assembly
Burner Head
Assembly
Tank
Bracket
Wing Nut
Washers
Tank
Bracket
Screw
Figure 3 - Attaching Heater to
Propane/LP Tank
Regulator
Knob
Tank
Bracket
Propane/LP
Tank
ASSEMBLY
1. Inspect heater components for possible
shipping damage. If any is found, imme-
diately notify dealer. Check to make sure
that all components are included with your
heater (see pages 8 and 9).
2. For15,000BTU Models Remove wing
nut attaching regulator assembly to the
burner. Use wing nut and washers to at-
tach tank bracket to the burner assembly
as shown in Figure 1.
1. Check heater for damage. If heater is
damaged, promptly inform dealer where
you bought heater.
2. Follow all of the safety and operating
precautions.
3. Check the "O" ring on the POL before
each use. Replace "O" ring if there is any
sign of wear or damage.
4. Make sure heater regulator knob is in the
OFF position.
5. 30,000 Btu Models Only Attach the
heater to the guard on the propane/LP
cylinder as shown in Figure 3. Tighten
knob on tank bracket to secure heater.
6. For All Models Connect regulator to pro-
pane/LP cylinder by rotating nut counter
clockwise into the propane/LP cylinder
valve outlet and securely tighten with a
wrench.
3. For30,000BTUModels Using 2 screws
from hardware package, attach tank
bracket to the burner assembly as shown
in Figure 2.