Use and Care Manual

www.factorybuysdirect.com
160946-01A6
OPERATION
Button on
Safety Valve
Figure 4 - Lighting Heater With a Match
Manual
Lighting
Hole
WARNING: Attach heater in
upright position. Never attach
heaterinahorizontalposition.
This could lead to dangerous
are-upsorre.
For use with 20, 40, 60 or 100 lb. propane
cylinder (bottle).
7. Securely tighten all gas connections.
8. Open the cylinder's gas valve and check
all connections for leaks. Apply a noncor-
rosive leak detection uid to gas joints.
Bubbles forming show a leak that must
be corrected. DO NOT USE A FLAME.
TO START HEATER
WARNING: When lighting the
heaterDONOTlookovertopof
heater(reector).Stand tothe
side of the heater during ignition.
Donotstandorhaveanypartof
yourbodyinfrontoftheheater.
WARNING: MAKE SURE
THERE IS NO OPEN FLAME IN
THEAREA.Fullyopenthevalve
on the propane/LP cylinder.
Read all lighting instructions before attempting
to ignite heater.
1. Turn the heater regulator knob counter-
clockwise to the HI position.
2. Place a lit match near the face of the heat-
ing element (mesh screen) of the burner
you are lighting, using the hole located on
the side of the reector. See Figure 4.
CAUTION: Do not light at the
orice.
3. Press button on safety valve admitting gas
to burner (see Figure 4).
WARNING:Donotpressvalve
buttonbeforeinsertingmatch.
4. When the gas on the face of mesh screen
lights, continue to hold valve button
pressed for 30 seconds, then release.
5. If ame goes out, wait 5 minutes and
repeat lighting procedure.
6. If heater will not light after repeated tries,
do not attempt to repair heater. Call Cus-
tomer Service toll free at 1-866-573-0674.
7. For dual burner models, repeat steps 1
through 4 to ignite the other burner.
8. After both burners or single burner, are lit,
turn heater regulator knob to the desired
heat setting (LOW, MED, HI).
6heatsettingcombinations:
Burner #1 Burner #2
LOW OFF
MED OFF
HI OFF
LOW LOW
MED MED
HI HI
TO STOP HEATER
1. Securely close valve on propane/LP cyl-
inder.
2. Turn heater regulator knob to the OFF
position. Wait 15 minutes for heater to
cool down before handling heater.
3. Always remove heater from propane/LP
tank after each use. Do not store heater
while attached to propane/LP tank. Re-
move heater from propane/LP tank by
turning fuel connector nut clockwise.
Always store propane/LP tank outdoors.
Never store propane/LP tank in an en-
closed area.
TO RESTART HEATER
1. Securely close valve on propane/LP cylinder.
2. Wait 5 minutes.
3. Restart following To Start Heater proce-
dure, page 5.