Use and Care Manual

www.factorybuysdirect.com
7160946-01A
SERVICING
Note: Use only original replacement parts. This will protect your warranty coverage for parts
replaced under warranty.
MAINTENANCE AND STORAGE
A hazardous condition may result if a heater
is used that has been modied or is not func-
tioning properly. When the heater is working
properly:
• Emitter screen is glowing bright orange-red.
• There are no ames above burner.
• Flame is burning on surface of screen and
not inside burner (ashback).
• There is no strong disagreeable odor, eye
burning or other physical discomfort.
• There is no smoke or soot internal or ex-
ternal to heater.
• There are no unplanned or unexplained
shut downs of heater.
The parts lists and exploded view show
heater as it was constructed. Do not use a
heater which is different from that shown. In
this regard, use only the hose, regulator and
cylinder connection tting (called a POL tting)
supplied with heater.
IMPORTANT: For this heater, regulator must
be set as shown in Specications, page 3. If
there is any uncertainty about regulator set-
ting, have it checked.
REPLACEMENT PARTS
PARTS NOT UNDER WARRANTY
Contact authorized dealers of this product.
If they can’t supply original replacement
part(s) call Customer Service toll free at
1-855-607-6557 for referral information.
When calling Customer Service have ready:
• Model number of your heater
• The replacement part number
1. Inspect heater before each use. Check
connections for leaks. Apply a noncor-
rosive leak detection uid to connections.
Bubbles forming show a leak that must be
corrected. Correct all leaks at once. Have
heater inspected at least annually by a
qualied service person.
2. Before each use, check the soft "O" ring
seat at the bullnose of the POL tting. If
"O" ring is cut, scuffed, or otherwise dam-
aged, replace it.
3. Inspect hose/regulator assembly before
each use. If hose is highly worn or cut,
replace. Use only a replacement hose
specied on page 9.
4. Turn off gas at propane/LP gas supply
cylinder when heater is not in use.
5. When heater is to be stored, connection
between propane/LP gas supply cylinder
and heater must be disconnected and
cylinder removed from heater and stored
out of doors and in accordance with
Chapter 5 of the standard for Storage and
Handling of Liqueed Petroleum Gases
ANSI/NFPA 58.
6. Use compressed air to gently blow out
any dirt or debris from burner tube.
PARTS UNDER WARRANTY
Contact authorized dealers of this product.
If they can’t supply original replacement
parts, call Customer Service toll free at
1-855-607-6557 for referral information.
When calling Customer Service or your
dealer, have ready:
• Your name
• Your address
• Model and serial number of your heater
• How heater was malfunctioning
• Type of gas supply and Propane/LP tank size
• Purchase date
Usually, we will ask you to return the defective
part to the factory