Use and Care Manual

www.factorybuysdirect.com
160942-01A6
40
50
60
70
80
90
THERMOSTAT F
THERMOSTATO F
O
O
START/RUN
ENCIENDA/OPERACION
DEMARRE/MARCHE
`
`
STANDBY
ASSEMBLED IN THE USA FOR:
ASSEMBLE AUX ETATS-UNIS PAR:
ENSAMBLADA EN LOS EE.UU. POR:
FACTORY BUYS DIRECT
500 BROWN INDUSTRIAL PKWY
CANTON, GA 30114
IMPORTANT: Review and un-
derstand the warnings in the
Safety section, pages 2 and 3.
They are needed to safely oper-
ate this heater. Follow all local
ordinances and codes when
using this heater.
TO START HEATER
1. Follow all ventilation and safety information.
2. Locate heater to provide maximum circu-
lation of the heated air. Follow all location
requirements noted in Safety, pages
2 and 3.
3. Fill fuel tank with fuel and attach fuel cap.
Use only kerosene, #1/#2 diesel/fuel oil,
JET A or JP-8 fuels to avoid risk of re or
explosion. Never use gasoline, oil drained
from crank cases, naphtha, paint thinners,
alcohol or other ammable fuels.
4. Plug heater’s power cord into approved,
grounded, three-wire extension cord.
Extension cord must be at least 6 feet
(1.8 m) long.
Extension Cord Size Requirement
• 6 to 10 feet (1.8 to 3 m) long, use 18
AWG (0.75 mm
2
) rated cord
• 11 to 100 feet (3.3 to 30.5 m) long, use
16 AWG (1.0 mm
2
) rated cord
• 101 to 200 feet (30.8 to 61 m) long, use
14 AWG (1.5 mm
2
) rated cord
5. Plug extension cord into standard 120
volt/60 hertz, 3-prong grounded outlet.
6. Turn thermostat knob to the desired tem-
perature setting.
If thermostat set temperature is higher
than the surrounding air temperature,
heater should ignite immediately. If heater
thermostat set temperature is lower than
surrounding air temperature, heater will
not ignite. Exposure to direct sunlight
or extreme cold may affect temperature
reading and/or thermostat operation.
The LED will ash for 8 seconds before
ignition. The LED will remain on during
heater operation, even if the heater is
cycled off by the thermostat. The LED will
ash rapidly if the heater shuts down for
any reason (Example: If out of fuel).
WARNING: This heater is
equipped with a thermostat.
Heater may start at any time.
TO STOP HEATER
1. Turn thermostat knob counterclockwise
to STANDBY.
2. Unplug heater when not in use.
TO RESET HEATER
1. Wait two minutes before restarting.
2. Turn thermostat knob to STANDBY for 10
seconds, then restart heater.
OPERATION
Figure 3 - Controls Display
Thermostat Knob
LED Light