Instruction manual

4-6 Operator’s Handbook
Select: Description
Adjust Contrast
Scroll to change contrast. The higher the number, the darker the print;
the lower the number, the lighter the print.
The print contrast controls the darkness of the printing on your supply.
The range is –28 to +40 and the default is 0. You may need to increase
or decrease the print contrast depending on your supply type. Having
the correct print contrast setting is important because it affects how well
your barcodes scan and how long your printhead lasts.
Serial Quality A label prints with barcodes to scan to check the
quality of serial bar codes.
Parallel Quality A label prints with barcodes to scan to check the
quality of parallel bar codes
3. Tap Back or X in the upper-right hand corner of the screen to return to previous screen.
Power Management
The printer will shut off after a predetermined amount of idle time.
The printer will “wake up” when you start using it again. Turn off the backlight to conserve
power when leaving the printer on and idle.
From the Control Panel, tap Power, Display, Backlight.
Radio Frequency Communications
Your printer may be able to communicate with other printers, an access point, or network via
radio frequency (RF) communications. Your System Administrator can tell you if you have this
feature and any special procedures you need to perform.