Instruction manual

Care & Maintenance 5-3
2. Remove the supplies. See “Removing Supplies” in Chapter 3 for more information.
3. Open the label deflector by gently pressing down with two fingers.
4. Clean the on-demand sensor with a soft cloth moistened with distilled water.
5. Reload the supplies, close the label deflector and supply cover.
To clean the black mark sensor:
1. Turn off the printer and open the supply cover.
2. Remove the supplies. See “Removing Supplies” in
Chapter 3 for more information.
3. Clean the black mark sensor with a dry cotton swab.
4. Reload the supplies and close the supply cover.
Cleaning the Scanner Window
Clean the scanner window whenever it appears to be dirty
or smeared. To clean it:
1. Moisten a soft cloth with distilled water. Do not use household cleaners to clean the
printer.
2. Wipe the window until it is completely clean.
Cleaning the Scanner Flex Cable
Occasionally, adhesive buildup appears on the
scanner flex cable, as shown below. To clean the
cable:
1. Turn off the printer and open the supply cover.
2. Inspect the scanner flex cable. At any place
that adhesive buildup appears, clean the cable
with 99% isopropyl alcohol and a cotton swab.
3. Close the supply cover.
Clearing Supply Jams
To clear a supply jam:
1. Turn off the printer and open the supply cover completely.
2. Open the label deflector by gently pressing down on it with two fingers.
3. Remove the supplies. See “Removing Supplies” in Chapter 3 for more information.
Black Mark
Sensor
Adhesive Buildup
Scanner Flex
Cable