Product specifications

Identifying and Replacing Failed Video I/O Boards
142
3. You can now remove the failed Video I/O board from the chassis.
To remove failed VIO boards:
1. Observe the safety precautions described in “Electrostatic Discharge Precautions” on
page 76 and “Safety and Regulatory Information” in the AirSpeed 5000 Setup Guide.
2. Power down the server and unplug all peripheral devices and the AC power cables.
3. Remove the server cover. For instructions, see “Removing and Replacing the Server Main
Cover” on page 134.
4. Disconnect any cables attached to any add-in cards.
5. Loosen the thumbscrews on the back cover, and slide the cover back to remove it from the
chassis.
The following diagram shows the location of the two (2) thumbscrews on the rear of the
server.
6. Loosen the thumbscrew on the card guide, and slide it over to remove it from the chassis.
The following diagram shows the location of the Card guide thumbscrew.
Two (2) Thumbscrews
Card Guide thumbscrew