Product specifications

Identifying and Replacing Failed Video I/O Boards
145
To replace VIO boards:
1. Observe the safety precautions described in “Electrostatic Discharge Precautions” on
page 76 and “Safety and Regulatory Information” in the AirSpeed 5000 Setup Guide.
2. (Option) If you have removed VIO 2 (the bottom board), gently replace the bottom Video
I/O board (VIO 2) into the riser card.
3. Gently replace the top Video I/O board (VIO 1) into the riser card.
4. Replace the Board Locking Bracket back down into its slot, and tighten the thumbscrews.
5. For each VIO board (VIO 1, VIO 2) that you replaced, reattach the SATA and Power cables
to the board as follows:
a. Reattach the Power Harness (yellow and black cable) to the Video I/O board.
b. Reattach the two SATA (red) cables to the Video I/O board.
Make sure the SATA cables are connected (Top to Top, and Bottom to Bottom)