Product specifications

AirSpeed 5000 Server Hardware Upgrade Checklist

159

Replacing the Video I/O Boards into the Chassis

This topic contains information on how to replace the Video I/O boards in the server chassis.

To replace the VIO boards into the chassis:

1. Observe the safety precautions described in “Electrostatic Discharge Precautions” on

page 151 and “Safety and Regulatory Information” in the AirSpeed 5000 Setup Guide.

2. (Option: For 4-channel model servers only) Gently replace the bottom Video I/O board (VIO

2) into the riser card.

3. Gently replace the top Video I/O board (VIO 1) into the riser card slot.

4. Replace the Board Locking Bracket back down into its slot, and tighten the thumbscrews.

5. Reattach the SATA and Power cables for each Video I/O board (VIO 1, VIO 2) as follows:

a. Reattach the Power Harness (yellow and black cable) to the Video I/O board.

b. Reattach the two SATA (red) cables to the Video I/O board.

Make sure the SATA cables are connected (Top to Top, and Bottom to Bottom).