User manual

AVIOSYS INTERNATIONAL INC IP MOTOR 9203 USER MANUAL
WWW.AVIOSYS.COM.
1. For 2 axis stepper motor: Working in 2 phase condition.
The Working voltage is no more than 12V and axis currency no more than 1A..
2. The 5 lines sequence is ︰ Ａ phase、Ａ＇phase 、Ｂ phase 、Ｂ＇phase 、ＣＯＭ。
3. The sequence to driver 9203 Module rotate CLOCKWISE ︰
ＡＢ phase → ＢＡ＇ phase → Ａ＇Ｂ＇phase → Ｂ＇Ａ phase。
If want to driver 9203 Motor rotate COUNTER CLOCKWISE ︰
ＡＢphase ← ＢＡ＇phase ← Ａ＇Ｂ＇phase ← Ｂ＇Ａphase 。
Software Installation – IP EDIT
Having power IP MOTOR 9203 on and connected its RJ45 network wire to the stepper motor,
user can install the software---ipedit.exe following the steps below.
1. Power on your PC, put the install disk to the CD-ROM. The disk will auto run and shows the
figure below:
2. Click the button driver in the left side, and then click IPEDIT3 in the pulldown menu. After that,
click the IPEDIT3 in the right figure and the computer will run it immediately.
You can find the ipeditv3.exe in the subdirectory of \Tools in the install disk. You can copy it to the
desk or anywhere you want to save it to, double click to run it.
3. You can finish its initial settings following the constructions in the next section.
NOTE: IP MOTOR 9203 need not any other driver of application software. All the operation
interfaces are built in the hardware. IPEDIT3.exe will bring more convenience for you looking for
the IP address.
CUSTOMER HOTLINE: [phone]. VER. 1.0
- 9 -