User manual

2. Connect Client setup :
A. Divide : this device word separate ly and do not use Inter-Control
B. Light : This device can control 9202 / 9212 (IP Power) - by change the default setting
of : Normal close or normal open
C. Motor : This device can control 9203(IP Motor) –control the tdirection of turning..
3. Controlled IP Address: Setting the Ip Address of controlled device .
In Inter - control mode when transfer , . the Out Light(P6.1/P6.2) will always on ，if the
maincontroller freeze the Out Light P6.1 is always on ，if the controlled device freeze , the light
of P6.2 is always on.。
2-1 For example : Control Ip Motor by DI board of IP Power 9212
Step 1 : Go to SETUP , change Connect Client and set as Motor ,
Step 2 : key in the IP address of controlled device (IP Motor)
Step 3 : Click Submit to confirm setting , whrn the count windows is off , the new login
windows jump out as following pictures.
- 16 -