User's Manual

Data Transferring
Bluetooth function:
What You Need
An Android device with Android version 4.3 or above and
hardware support for Bluetooth 4.0.
An iOS device with iOS version 5 or above and hardware
support for Bluetooth 4.0. All devices Apple released
since the iPhone 4S (including the 4S) do, the older ones
don’t.
Note:
Please refer to the instruction manual of your smart
phone for how to activate the Bluetooth function.
Set Up Process
1. Download an app which supports Bluetooth 4.0 from
the iTune App Store or Google Play.
2. Enable Bluetooth on your mobile device.
3. Open the app and activate the function.
4. Turn on the BPM64R.
5. The app should automatically detect your BPM64R.
Tap the BPM64R that is showed in the device list.
6. Your BPM64R is now successfully connected to
your mobile device. Every measure reading will be
transfer to your mobile device automatically.
You can send results in memory zone as following step
1.Press Memory recall button of blood pressure monitor
to enter memory mode. The symbol AVG and M will
appear on the display and the number of memory index is
“00”.
2.Turn on the bluetooth function of device to search the
blood pressure monitor. Then the blood pressure monitor
will be searched and connected the bluetooth device.
3.After the connection is completed, you can press
memory recall button to display the memory result on
LCD. Each result showed on LCD, the result will be
transmitted by bluetooth immediately.
USB function:
Connect the blood pressure monitor to your PC using the
USB Cable. appears on the display. Begin the data
transfer in the PC software. During the data transfer, an
animation is shown on the display.
• A successful data transfer is displayed
as in figure 1.
If the data transfer is unsuccessful, an error
message appears as in figure 2.
In this case, interrupt the PC connection and
start the data transfer again.
After 30 seconds of not being in use or if communication
with the PC is interrupted, the blood pressure monitor
switches itself off automatically.
13
Care and Maintenance
1. Clean the device and arm cuff carefully only with a
slightly moistened cloth.
2. Do not immerse the device in water. It may cause
damage if water enters.
3. Do not use any gas, strong detergent, or solvents to
clean the device, including the arm cuff.
4. Disconnect the cuff and tubing from the monitor prior
to storing.
5. Do not use any liquids on the monitor or cuff.
6. Use a soft, dry cloth to clean your monitor.
7. Do not store in direct sunlight, dust or excessive
humidity.
8. Avoid extreme temperatures.
9. Do not disassemble the monitor or cuff.
10.Remove batteries if the monitor will not be used for
an extensive period of time.
Technical Specification
• Measuring range :
Blood Pressure : 30~280 mmHg
Pulse Rate : 40~199 beats/min
• Calibration Accuracy:
Blood Pressure : ± 3 mmHg
Pulse rate : ± 4% of reading
• Operating environment :
10oC~40oC (50oF~104oF)
with relative humidity up to 85%
(non condensing)
• Storage/ Transportation
environment :
-20oC~+50oC (-4oF~+122oF)
with relative humidity up to 85% (non
condensing)
• Power Source : 4 x 1.5 V AA batteries
• Weight : approx. 250g (exclude batteries)
• Dimensions : approx. 113mm x 140mm x
57mm(W x H x D)
• Cuff circumference: approx. 22 ~ 42 cm (9” ~
17”)
14