Owner's manual

Errors and omissions excepted.

OT20A

OUTDOOR AMPLIFIED AERIAL

Order ref: 120.910UK

User Manual

Introduction

This outdoor aerial is designed for analogue and digital TV broadcasting. It can receive TV signals in UHF and VHF bands,

as well as DAB and FM radio signals. It is the perfect solution for caravans and boats.

Features

• Variable gain control

• Built-in high gain low noise amplifier

• Powered via either AC or DC input

• Ideal for DVB-T, DVB-T2 and DAB or FM radios

Included in box:

1. Outdoor aerial

2. Mounting accessories

3. Waterproof kit

4. Power supply

5. 6m of coaxial cable

6. 1.2m cable with RF male and F connector

7. DC power lead

Installation

Using the 2 screws supplied, connect the mast fixture to the aerial body and secure. (See below)

Connect the coaxial cable to the amplifier input. Plug the F connector to the socket on the bottom

of the aerial and push the waterproof kit over it. (See images below)

PAGE 1
OT20A Order ref: 120.910UK User Manual OUTDOOR AMPLIFIED AERIAL Introduction This outdoor aerial is designed for analogue and digital TV broadcasting. It can receive TV signals in UHF and VHF bands, as well as DAB and FM radio signals. It is the perfect solution for caravans and boats. Features • Variable gain control • Built-in high gain low noise amplifier • Powered via either AC or DC input • Ideal for DVB-T, DVB-T2 and DAB or FM radios Included in box: 1. Outdoor aerial 2. Mounting accessories 3.
PAGE 2
Set-up Examples Install directly to TV Install though set-top box After the mounting and installation is finished, adjust the aerial to the best position to receive the signal. Keep the aerial away from interference sources such as air conditioners, hair dryers, microwaves etc. Ideally the aerial should be installed as high as possible. Specification Power supply 230Vac, 50Hz (3W) / 12Vdc, 50mA Frequency range: UHF 470MHz – 862MHz Frequency range: VHF 40MHz – 230MHz Gain 20dB Impedance 75Ω Weight 1.